Interfaces, Displays and Operator Controls
Fault Mask
Display Mode
3 2 1
LED off | LED on | LED on |
Note
LED 3 exists only on devices with digital inputs.
With the line 1 or 2 LEDs, the fault mask indicates whether the power supplies are monitored with the signaling contact.
L1 or L2 LED
-Lit green; in other words the corresponding power supply (line 1 or line 2) is monitored. If the power supply falls below 14 V, the signaling contact responds.
-Not lit, in other words the corresponding power supply (line 1 or line 2) in not monitored. If the power supply falls below 14 V this does not trigger the signaling contact.
The fault mask can be set again with the button on the front panel of the OSM/ESM (see 4.2.4.2)
The "Select/Set" button on the front panel of the OSM/ESM changes the display mode of the display mode LEDs. Using this button, a new status can be programmed for the fault mask (see 4.2.4.2)
Industrial Ethernet OSM/ESM | 57 |
