Sierra 200 System Normal Commands

System Normal Commands

These commands return the control system to a known, safe state. Some normal

commands reset parts of the control system and other commands can reset all control

system states to a known condition.

Sets normal conditions for the entire control system including all groups.

• Sets CTCSS / DCS required to on,

• Sets link delay on

• Connects or disconnects (link on/off) ports according to their

normal link state as defined in the group definitions (all on in the

default configuration)

• Turns on audio loopback on repeater ports only

• Turns off audio loopback on all other port types

• Turns remote monitor modes off

• Disables remote base transmitters

• Executes remote normal (C303) command.

Operates on the current group only.

• Connects link, VOIP/IRLP, and remote base ports according to their

normal

• Link state as defined in the group definitions

• Disconnects (unlinks) all local radios.

• Disables remote base transmitters (use C380 to enable).

Operates on the current group only

• Connects all ports which are defined as normally linked in the group

definitions

• Not connected for VOIP and remote base ports.

• Disables the remote base transmitters (enable with C380).

• This can be used to reconnect the repeaters after a link normal (C301)

command.

• Clears unlocked conditions

• Turns off the force transmitter on test condition

• Turns off the test tones

• An unlock code will need to be reentered before executing subsequent