78
System Configuration Commands
Unlock Code Management Commands
C110 (su) Set unlock code Sets unlock code for enabling locked commands.
This command requires a super unlock code (code #0 or #1). The unlock code
number is returned in the telemetry if successful. No checking is done for
conflicts with commands, so be careful that a command is not the same as the
unlock code or is contained in the leading characters of the unlock code. The
lowest index blank unlock code is set.
Syntax is C110sssssD
Up to 6 characters can be used (recommended). The terminating D is not
used if 6 characters are entered. The unlock code characters must be numeric
(0..9); ABCD are not allowed.
C111 (su) Delete unlock code Deletes the matching unlock code.
This command requires a super unlock code. Unlock code #0 cannot be
deleted with this command. The unlock code index is returned if successful.
Syntax is C111sssssD
C112 (su) Delete unlock code index Deletes a specific unlock code number.
This command requires a super unlock code. Unlock code number 0 cannot
be deleted. Confirms if an unlock code is deleted. Does not confirm if index
is out of range, or no unlock code currently exists at the specified index.
Syntax is C112nnD
The system supports 20 unlock codes, with index 0..19
C113 (u) Check unlock code
Returns the index of a matched unlock code. Returns nothing if there is no
match.
Syntax is C113sssssD.