18 | QUIRC User Guide |
Examples:
oc IDL put controller in dle mode
>oc RDC perform detector read
diag l1 hcnt frcgdata]i4MHz loopback test mode.
Test fiber optic interface in hardware loopback mode. Receiver is wired for operation at 4MHz, and a fiber is connected directly between the receiver and transmitter. This test runs cnt loops of 65536 words each, with values 0 through 0xFFFF. If the c option is specified, then data is a value (in hex) to be sent repeatedly. If the r option is specified, then data is used as a seed for a random number generator and 65536 words of random data are sent per loop.
diag l3 cnt [frcgdata]iTiming board loopback test
Loopback test with timing board in place. Must have code downloaded or be in cold reset state. Similar to L1 in other respects.
diag l4 cntidata read loop test
Test interface by repeatedly performing the RDC command and looking for data. If the proper number of data words are not received, an error message is generated and the
>program counts the errors.
diag l5 hcnt [frcgdata]iTiming board loopback test: high 16
Same as L3, but tests high 16 bits of data word. Must have code downloaded that supports the THI command (e.g. quircop1.asm)
