Silex technology PRICOM C-6400W manual Topic Explain Factory Default

Users Manual CX2

- NetBEUI/NetBIOS parameter

Topic	Explain	Factory Default
NetBEUI Protocol	Enable/Disable NetBEUI protocol operations	ENABLE
NetBIOS over TCP	Enable/Disable NetBIOS over TCP protocol operations	ENABLE
	Specify a computer name. The name set here is shown	PRxxxxxx
Computer Name	as a computer in Windows Explorer. The name must	xxxxxx is lower 6 digits
	be different from those of other computers.	of Ethernet Address
	Specify the workgroup that this print server belongs to.
Workgroup	Enter the default workgroup name or an existing	PRINTSERVERS
	workgroup name. A new workgroup name that does not
	exit in the network is not shown as Workgroup.
	Set the description of the print server. The information
Comment	set here is shown as the description of the print server	PRICOM C-6400W
	in Windows Explorer.
Brower Master	Enable/Disable Brower Master operations	ENABLE

- SNMP parameter

Topic	Explain	Factory Default
Authentic Community	Specify the authentication community name of SNMP.
	This community name is authenticated when an SNMP	public
	set request is received.
Trap Community	Specify the trap community of SNMP. This community	public
	name is used when the print server send a trap.
	Specify the destination IP address of the SNMP trap.
	The value is a four-part series of numbers separated by
Trap Address(IP)	decimal points. Such as "xxx.xxx.xxx.xxx". When the	0.0.0.0
	value is "0.0.0.0"(default), this item is disabled and a
	trap will not be generated in any case.
SysContact	Specify the SysContact of the MIB-2 object. The e-mail	none
	address of the network administrator is used.
SysName	Specify the SysName of the MIB-2 object. The host	none
	name or domain name of the print server is used.
SysLocation	Specify the SysLocation of the MIB-2 object. The	none
	location of the print server is used.
	Select whether to allow or disallow the "Enable Authen
Enable Authen Trap	Trap" of the MIB-2 object. If a violation for the	2
	community occurs "allow" is the setting, the SNMP trap
	is sent to the IP address specified in "TRAP Address"

Appendix 38