Sim2 Multimedia HT5000 installation manual Memories

HT5000

Some of these parameters may not be available for certain inputs or certain input signals.

The menu page for the Memories management functions is activated by pressing the key on the remote control.

The operations that can be performed on each memory selected are described here below.

Save memory

To save the image parameter current values in memory 1, move the cursor to line ‘1’ with the ▼ and ▲ ‚ keys and open the pull-down menu by pressing the ◀ key (Fig.26). Now select Save current settings. To confirm the operation, the message Current settings saved in Memory appears in the botton line. Memories 2...6 can be saved using the same procedure.

Memories
0	Auto
1	S	Save current settings
2	I	Save initial settings
3	S	MEMORIARename 1
4	S	MEMORY 4
5	S	MEMORY 5
6	S	MEMORY 6

Fig.26

Recalling a memory

To retrieve memories select the required line and press ▶. The parameters stored in the selected memory will be applied to the displayed image, while a confirmation message will be displayed.

The recalled Memory will be associated with the source and signal type, and will be automatically recalled every time that particular source and signal type combination is selected.

Restore memory to original settings

To restore the original values of a previously modified Memory, select the line relative to the Memory in question and open the corresponding drop-down menu (◀ key). Select the line ‘Save initial settings’.

To confirm the operation, the message ‘Initial settings saved in Memory 1’ is shown at the bottom of the display and the letter “I” appears to the left of the memory name.

Rename a memory

All Memories can be named. To assign a name (with a ma- ximum length of 12 alphanumeric characters) to a Memory, select the option ‘Rename’ from the corresponding pull-down menu. The text is input in accordance with the method descri- bed in the paragraph ENTERING TEXT.

Restore current values

When you enter the MEMORIES menu a copy of the current settings is saved in a temporary memory (designated by 0

-AUTO). Once one or more memories have been recalled, you can restore the settings that were effective at the moment the Memories menu was accessed by selecting Memory ‘0’(0 - AUTO). Note that this operation must be executed before the Memories’ menu page disappears (30 seconds after the final operation with the remote control or keypad). The next time it appears, in fact, the temporary memory will contain new information that takes account of any Memories that were selected in the penultimate access to the ‘MEMORIES page.

Memory 0 can be used even when you do not wish to enable Memories management for the signal in use. Once Memory 0 has been selected, when a source is chosen, the settings that were effective at the time the Memory was previously recalled will be automatically applied.

24