Sim2 Multimedia HT5000 installation manual Switching the Projector on and OFF

HT5000

5 SWITCHING THE PROJECTOR ON AND OFF

WARNING: Connect the projector to a power supply with a

nominal voltage within the following values: 100-240 V AC, 50/60 Hz. It must be earthed (Fig. 8).

Power Switch:

Position I: On

Position 0: Off

I 0

Power Plug

Fused

Power Socket

Fig. 8

In position I the projector will initialise itself (red and green leds on) and then goes into standby mode (red led on) (Fig. 9).

I 0

Fig. 9

Switch on from standby

With the remote control press one of the keys:

-0 to select the last imput selectet after last switching of.

-1-9 to select the correspondent imput

With the keypad: press the ON/OFF button.

0

0
I	Fig. 10

When the unit is switched on from standby the lamp switches on; after a brief period of warming up, the image displays (blue led on). The projected image comes from the input selected when the unit was last switched off (Fig. 10).

If a very short time has passed since the unit was last switched off, the lamp may not switch on because it is too hot.

Just wait a few minutes for the lamp to cool down sufficien- tly.

Switching off and returning to standby

With the remote control: press .

With the keypad: press ON/OFF button.

When switching off, the projector goes into stand-by mode and stores the input selection at the time of switch-off.

The fans keep running until the lamp cools down (blue and red leds on), after which they automatically switch off. Do not switch off the projector with the power switch until the fans have stopped running.

11