TABLE 2: POINTS LIST IN DESCRIPTION ORDER (CONTINUED)
| BACnet | BACnet |
|
|
|
|
|
Read/ | Object | Object |
|
|
|
|
|
Write | Type | Inst | Descriptor | Default | Min | Max | Point Description |
R | (5) BV | 14 | LOW_SUP_VOLT | – | – | – | Low Supply Voltage (0=comps not overrid- |
|
|
|
|
|
|
| den by LSV, 1=comps overridden) |
R/W | (5) BV | 96 | MANUAL_WRITE | – | – | – | Manual Write Command to ModlINC |
R/W | (2) AV | 28 | MAX_TH_OFSET | 3 | 0 | 5 | Max Temperature/Humidity Setpoint Offset |
R/W | (2) AV | 30 | MAX_DMV_ECON | 50 | 0 | 100 | Maximum Demand Ventillation Economizer |
|
|
|
|
|
|
| Position |
R | (5) BV | 11 | MODBUS_ALARM | – | – | – | Modbus Communication Alarm |
R | (5) BV | 9 | MOD_EX_INST | – | – | – | Modulating Exhaust Installed |
R/W | (2) AV | 61 | MWU_RAT_STPT | 70 | 50 | 85 | Morning |
|
|
|
|
|
|
| Air Temperature Setpoint (degrees F) |
R | (5) BV | 6 | – | – | – | Morning | |
R | (2) AV | 16 | NUMBER_COMPS | – | – | – | Number of Compressors Available |
R | (2) AV | 48 | NUMBER_HEAT | – | – | – | Number of Heat Stages Available |
R/W | (2) AV | 1 | OCC_COOL_SP | 72 | 45 | 99 | Occupied Cooling Setpoint |
R/W | (5) BV | 1 | OCCUPIED_ENA | – | – | – | Occupied Enabled |
R/W | (2) AV | 50 | OCC_HEAT_SP | 68 | 45 | 99 | Occupied Heating Setpoint |
R | (5) BV | 93 | OCC_COMS_ENA | – | – | – | Occupied Thermostat or Communication |
|
|
|
|
|
|
| Input Enabled |
R | (2) AV | 17 | OP_COOL_STPT | – | – | – | Operating Cooling Setpoint |
R | (2) AV | 49 | OP_HEAT_STPT | 68 | 45 | 99 | Operating Heating Setpoint |
R/W | (2) AV | 69 | OP_STPT_DIF | 1 | 1 | 5 | Operating Setpoint Differential |
R/W | (2) AV | 74 | OAT_COOL_L_O | 45 | 0 | 100 | Outdoor Air Temperature Cooling Lockout |
|
|
|
|
|
|
| Temperature |
R/W | (2) AV | 54 | OAT_HEAT_L_O | 75 | 0 | 100 | Outdoor Air Temperature HeatingLockout |
|
|
|
|
|
|
| Temperature |
R | (2) AV | 11 | AMB_AIR_ENTH | – | – | – | Outside Air Enthalpy |
R | (2) AV | 10 | AMB_AIR_HUM | – | – | – | Outside Air Humidity |
R | (5) BV | 37 | OAH_SENSOR | – | – | – | Outside Air Humidity Sensor Enabled |
R | (2) AV | 7 | AMB_TEMP | – | – | – | Outside Air Temperature |
R | (2) AV | 9 | OAQ_VALUE | 1000 | 0 | 5000 | Outside Demand Ventilation (OAQ) Value |
|
|
|
|
|
|
| (PPM) |
R | (5) BV | 8 | PWR_EX_INST | – | – | – | Power Exhaust Installed |
R | (5) BV | 20 | POP_ENABLED | – | – | – | |
R/W | (2) AV | 81 | POP_HOURS | 4 | 0 | 23 | |
R/W | (2) AV | 82 | POP_MINUTES | 0 | 0 | 59 | |
R | (5) BV | 17 | PURGE_SWITCH | – | – | – | Purge Switch Status (0=open,1=closed) |
R/W | (5) BV | 12 | REDLINE | – | – | – | Redline (0=clear redline, 1=set redline |
|
|
|
|
|
|
| operation) |
R | (5) BV | 4 | REM_CONT_ENA | – | – | – | Remote Control Enabled |
R | (2) AV | 13 | RET_AIR_ENTH | – | – | – | Return Air Enthalpy |
R | (2) AV | 12 | RET_AIR_HUM | – | – | – | Return Air Humidity |
R | (2) AV | 5 | RET_AIR_TEMP | – | – | – | Return Air Temperature |
R | (5) BV | 38 | RAH_SENSOR | – | – | – | Return/Inside Air Humidity Sensor Enabled |
R | (2) AV | 6 | SPACE_TEMP | – | – | – | Space (Indoor) Air Temperature |
8 | Johnson Controls Unitary Products |
