REMOVIN G / ATTACHING THE PRESSER F OOT
Turn the Power On /Off & Speed Cont rol Switch to th e “off” positio n and make sure th e needle
is in its highes t position.

Removing t he Presser Foo t

Raise the Pres ser Bar by lifti ng the Presser F oot Lifter. Pres s the Presser Fo ot Lever, locate d
in back of the Pre sser Foot Hold er and the foot wi ll disengage .
WINDING T HE BOBBIN
The bobb in case i s
magne tized . When th e metal b obbin i s used, c orrec t tensi on for th e bobbi n threa d can be
achie ved. The refor e, do not u se tran spare nt or pla stic bo bbins – u sing tr anspa rent or p lasti c
bobbi ns will r esult i n poor st itch qu ality d ue to lac k of tens ion on th e bobbi n threa d.
Alway s use met al bobb ins. Co ntact y our Auth orize d SINGE R retai ler for m ore
infor matio n, or vis it www.s inger. com.
®
Place th e spool b ase, thr ead and s pool cap o nto the sp ool pin . Pull the t hread o ut from th e
spool. S lip it in to the thr ead gui de, then w ind it aro und the b obbin te nsion g uide, as i llust rated.
Put the e nd of the t hread t hroug h the hol e in the bo bbin, a s shown . Place t he bobb in onto
the bob bin win der as fa r as it wil l go.
Holdin g onto th e end of the t hread , push the b obbin wi nder fi rmly to th e right , up again st the
bobbin w indin g stoppe r. Step on th e foot co ntroll er to beg in windi ng the bo bbin, st op to tri m
the thre ad tail . Step on th e foot co ntroll er again t o resum e windin g the bob bin. Whe n the bob bin
is full, p ush the s pindle t o the lef t, clip th e thread a nd remo ve the bob bin fro m the wind er.
14
13

Attachin g the Presser Fo ot

Raise the pres ser foot using t he Presser Foo t Lifter. Place th e foot under the p resser foot ho lder,
then lower the p resserfoot h older until th e cut-out is dir ectly above th e pin.
The presser fo ot will engage a utomatical ly.
The Vivo c reate & r epair m achin e by SING ER uses m etal bo bbins .
®