Sirius Satellite Radio 10 manual Cleaning the Unit, Installation in a Vehicle

Cleaning the Unit

If the unit becomes dirty, turn its power off and wipe it clean with a soft dry cloth. Do not use hard cloths or paint thinner, alcohol, or other volatile solvents to clean the unit. These may cause damage or remove indicator characters.

Warning

Do not operate the unit in a way that might divert your attention from driving safely. As a driver, you alone are responsible for safely operating your vehicle in accordance with traffic safety laws at all times.

Installation in a Vehicle

1.Determine where you want to mount the CRSR-10 on the windshield. You may also want to inquire about optional mounting methods at your dealer.

•Do not install the CRSR-10 where it may obstruct your view through the windshield or your view of your vehicle’s indicator displays.

•Do not install the CRSR-10 where it will hinder your access to the vehicle’s controls.

•Do not install the CRSR-10 where it may hinder the function of safety devices such as an airbag. Doing so may prevent the airbag from functioning properly in the event of an accident.

•Find a location that provides good visibility of and access to the CRSR-10’s front panel.

•Make sure the windshield is clean and dry.

Press	Cam Lever
Button
	in locked
	position

Knobs

Yoke

Button

HolderAdjusting

Screw

•Loosen both knobs and lift the yoke away from the “Press” button in an orientation similar to above.

•Place the cam in the down position and push the window mount onto the window by pressing the “Press” button.

•With your finger on the “Press” button, pull up on the cam lever to secure the mount in place.

•With the knobs loose, move the yoke into a position that will allow you to see the CRSR- 10 screen and access the buttons.

•Tighten the knobs securely.

•Now that the mount is in place, slide the CRSR-10 into the button holder.

Note: if the CRSR-10 rotates too much while on the suction mount, tighten the adjusting screw located in the center of the mount.

3

6

5

4

3.Attach the Adaptor to the CRSR-10 as shown left below.

4.Plug the cigarette lighter adapter into the back of the Adaptor where it is labeled “Power”. Don’t plug the adapter into the cigarette lighter until the installation is completed.

5.Plug the antenna cable into the Adaptor where it is labeled “Antenna”.

•Find an antenna location on a metal surface of your vehicle at least 12" x 12", and at least 6" from a window. Best reception is achieved with the antenna mounted on the roof or trunk for convertibles. If the vehicle has a roof rack or skid ribs, it may be necessary to mount the antenna off center.

6.If you would like to hard-wire your CRSR-10 to your car stereo that has an aux input (RCA jacks), plug the supplied audio cable into the back of the Adaptor where it says “Audio”. Plug the audio cable’s white (L ch,) and red (R ch.) connectors into your car stereo.

7.The antenna’s powerful magnet will secure it to the metal surface.

6
	Sanyo CRSR-10 User Guide

	7
Sanyo CRSR-10 User Guide