Section 13 Troubleshooting
This section provides possible solutions to issues regarding the installation and operation of your EZ Connect Turbo Wireless Bridge. If the solution you are looking for is not listed here, please visit SMC Networks web site at www.smc.com.
Before you begin troubleshooting your EZ Connect Turbo Wireless Bridge, please make sure you are running the latest firmware. You can download the latest firmware from www.smc.com.
1.If you are not able to connect to the Wireless Bridge through a Web Browser, please check the following:
•First, make sure the computer trying to connect to the SMC2482W is in the correct network range. By default, the SMC2482W has an IP address of 192.168.2.55.
•Second, you can use the Utility to scan for the SMC2482W and change the IP address to an available IP address on your network.
2.If you are not able to scan for the Wireless Bridge with the Utility while it is connected to your hub, switch, router, you can connect it directly to your computer with a crossover cable to test the connection. Also make sure all firewall soft- ware is turned off and that all LEDs are on for the SMC2482W.
3.If you are not able to gain wireless access to the SMC2482W Wireless Bridge, you will first need to check and configure the correct mode. Wireless clients can connect to the SMC2482W while it is in Access Point mode. If the Wireless Bridge is set to either
4.Please see Section 1.2 for the SMC2482W reset procedure.
44
