
INSTALLING THE SWITCH
Return/24VDC (Source A)
Return/24VDC (Source B)
Figure 3-7 DC Plug Connections
7.Push each wire about half an inch into the opening on the plug, and tighten down the clamp screw securely. You should not be able to pull on the wire and dislodge it.
8.Insert the power plug in the power receptacle on the left side of the front panel.
9.At the power source, turn on the power for the feed lines or power bus.
10.After the power source is tuned on, set the power button on the front of the power conversion module to the ON position (marked
11.Check the indicators on the power conversion module as the switch is powered on to verify that the
12.If you have installed both a primary and redundant power conversion module, verify that the LEDs on both modules are lit as indicated in the preceding step.