Smeg STA4645U Interrupting a program, Changing the current program, Canceling the current program

USER INSTRUCTIONS EN

2.2.4 Interrupting a program

To interrupt the current program simply open the door of the dishwasher; to restart the program, simply close the door again. The program restarts from where it was interrupted.

If it is necessary to open the door during the washing cycle, the program will be interrupted, the relative indicator light will continue to

flash and a beep will indicate that the cycle has not terminated. Wait for about 1 minute before closing the door and continuing with the program. When the door closes, the program will start from where it was interrupted. This operation should be performed only if neces- sary as it could cause irregular program performance.

2.2.5 Changing the current program

To change the current program, simply open the door of the dishwasher and select the new program. Close the door to run the new program automati- cally.

2.2.6 Canceling the current program

•To cancel the current program, open the door and press and hold down the program selection button (ref. 3 fi g. 2-02) for a few seconds until the indicator lights of the fourth and fi fth programs turn on (ref. pr. 4, pr. 5 fi g. 2-03).

•Close the door again.

•After about 1 minute, the dishwasher terminates the cycle and the indicator lights of the fourth and fi fth programs (ref. pr. 4, pr. 5 fi g. 2-03) start fl ash- ing.

pr. 4	pr. 5
	Fig. 2-03

Rev 0.0 9