Section 4 - ADJUSTMENT & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance or service with the engine or blades running. STOP blades. STOP engine. Set brake. Remove key. Remove spark plug wire from spark plug and secure wire away from spark plug. Engine and components can be extremely hot. Avoid burns by allowing engine and components sufficient time to cool.
4.4.7.TRACTION DRIVE BELT REPLACEMENT
42” Mower Deck Removal
It is necessary to remove deck in order to replace belts. Remove deck as follows:
1.Place tractor on a firm, level surface such as a driveway or garage floor and set the park brake.
2.Turn engine “OFF”. Remove key.
3.Lower the deck to lowest setting.
4.Remove hair pin and washer securing front lift cable to front lift arm. See Figure 4.19.
5.Remove hair pins from the front deck hanger rod and slide out the rod from deck hanger bracket. Front lift arms will be now be disconnected. See Figure 4.20.
| CLEVIS |
HAIR PIN | PIN |
WASHER |
|
JAM NUT
FRONT LIFT CABLE
42” DECK SHOWN
FIGURE 4.19
6.Hold front of deck "UP" and slide the front deck hanger rod to the right and out then lower the front of deck to the ground.
7.Remove deck drive belt from engine pulley bottom groove. See Figure 4.21.
RIGHT
SIDE SHOWN
DECK HANGER BRACKET
FRONT DECK
HANGER ROD
FRONT | HAIR PIN | |
LIFT ARM | ||
|
FIGURE 4.20
FIGURE 4.21
(Continued On Next Page)
FRONT AXLE
23
