Solid State Logic 82S6XL090A owner manual Installation, Voltage Selection

XLogic E Signature™ Channel Owner’s Manual

3.0Installation

3.1Voltage Selection

Before connecting the mains supply ensure that the voltage range selector next to the IEC socket on the rear of the unit is correctly set. The input setting must be confirmed before applying power. The input module can be configured to be one of 4 voltage settings (one of which is invalid and should not be used – see below). The setting is indicated by a plastic pin protruding through the appropriate hole in the fuse panel.

Lever here…	Before Connecting to	110V
	the supply, see the
		120V
	Installation Instructions.
		230V
	DISCONNECT POWER	240V
	BEFORE REPLACING FUSES

Mains Inlet Module (set for ‘240V’)

The setting is altered by a small vertical PCB which can be fitted in 4 positions.

To change the setting:

Switch off and remove the IEC lead.

Voltage setting PCB

(under cover)

Using a small flat-bladed screwdriver, lever open the fuse panel to the right of the connector.

At the right hand side is a vertical PCB with a plastic key which indicates the setting. Using pliers, pull out the PCB.

The PCB has to be rotated until the desired voltage is shown along the edge which plugs into the module. The plastic key (and this bit is quite fiddly) must also be rotated so that it points out of the module and so that the round pin aligns with the appropriate hole in the cover panel; (refer to the diagrams opposite).

Re-insert the PCB and replace the fuse panel. The plastic pin should project through the appropriate hole.

	240	230
100

120

100V Setting

(Use for 90-105V)

100

120

240

230

120V Setting

(Use for 105-125V)

	120
230	100
	240

230V Setting (Do not use)

230 240

120

100

240V Setting

(Use for 220-240V)

Mains Inlet Voltage Setting PCB

These diagrams show the PCB arrangements for the different voltage settings.

Note that where the mains voltage is a nominal 230V, the ‘240V Setting’ should be used – not the ‘230V Setting’!

Page 6