Supplied accessories:

Card remote commander: RM-X150

Parts for installation and connections (1 set) Front panel cover (1)

Optional accessories/equipment:

DVD navigation system: NVX-HC1

Rotary commander: RM-X6S, RM-X4S BUS cable (supplied with an RCA pin cord): RC-61 (1 m), RC-62 (2 m)

CD changer (10 discs): CDX-757MX

CD changer (6 discs): CDX-T70MX, CDX-T69

MD changer (6 discs): MDX-66XLP

Mobile DVD Player: DVX-11B

Source selector: XA-C30

AUX-IN selector: XA-300

US and foreign patents licensed from Dolby Laboratories.

Note

This unit cannot be connected to a digital preamplifier or an equalizer which is Sony BUS system compatible.

Design and specifications are subject to change without notice.

•Lead-free solder is used for soldering certain parts. (more than 80 %)

•Halogenated flame retardants are not used in the certain printed wiring boards.

•Halogenated flame retardants are not used in cabinets.

•VOC (Volatile Organic Compound)-free vegetable oil based ink is used for printing the carton.

•Packaging cushions do not use polystyrene foam.

Troubleshooting

The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.

General

The operation buttons do not function.

Press the reset button (page 6).

No sound.

•The volume is too low.

•The ATT function is activated, or the Telephone ATT function (when the interface cable of a car telephone is connected to the ATT lead) is activated.

•The position of the fader control (Fader) is not set for a 2-speaker system.

•The CD changer is incompatible with the disc format (MP3/ATRAC CD).

t Play back with a Sony MP3 compatible CD changer, or this unit.

The contents of the memory have been erased.

•The reset button has been pressed. t Store again into the memory.

•The power cord or battery has been disconnected.

•The power connecting lead is not connected properly.

No beep sound.

•The beep sound is cancelled (page 32).

•An optional power amplifier is connected and you are not using the built-in amplifier.

The display disappears from/does not appear in the display window.

The display disappears if you press and hold (OFF).

tPress and hold (OFF) again until the display appears.

Stored stations and correct time are erased. The fuse has blown.Makes noise when the ignition key is in the ON, ACC, or OFF position.

The leads are not matched correctly with the car’s accessory power connector.

No power is being supplied to the unit.

•Check the connection. If everything is in order, check the fuse.

•The car does not have an ACC position. t Press (SOURCE) to turn on the unit.

38