Presetting satellite tuner channels

1 Select a channel you want to preset.

For details on this operation, refer to “Selecting channels from a category (CATEGORY TUNING)”.

2 Press SHIFT, then press ENT/ MEM.

You can also use MEMORY/ENTER on the receiver.

“MEM” lights up on the display.

3 Press PRESET + or PRESET – to select a preset number.

You can also select the number by pressing SHIFT, then numeric buttons. Preset numbers from 1 to 30 are available. Channel 1 is preset for the preset numbers when you purchase the receiver.

4 Press ENT/MEM.

If SHIFT indicator is light off before you press ENT/MEM, press SHIFT.

You can also use MEMORY/ENTER on the receiver.

“MEM” lights off.

5 Repeat steps 1 to 4 to preset another channel.

Selecting a preset channel

1Press XM to select “XM RADIO” or press SIRIUS to select “SIRIUS”.

2Press PRESET+ or PRESET – repeatedly to select the preset channel you want.

You can also press SHIFT, then numeric buttons to select the preset channel you want. Then, press ENT/MEM to enter the selection.

You can also press TUNING MODE on the receiver repeatedly to select “PRESET” then use TUNING +/– to select the preset channel you want.

Using the Remote

Operating each component using the remote

When you program the remote to control the following Sony or non-Sony components, you can use the buttons on the remote that are marked with circles. Note, however, that some buttons may not operate your component.

If you want to change the contents of the input list to match your particular components, see “Programming the remote” (page 120).

118US