Test Tone menu parameters

xTest Tone

• OFF

• AUTO

The test tone is output from each speaker in sequence.

• FL, CNT, FR, SR, SBR, SBL, SB, SL, SW You can select which speakers will output the test tone.

xPhase Noise

•OFF

•FL/FR, FL/CNT, CNT/FR, FR/SL, FR/SR, SR/SL, SR/SBR, SBR/SBL, SR/SB, SBL/ SL, SB/SL, SL/FL, FL/SR

Lets you output the test tone sequentially from adjacent speakers.

Some items may not be displayed, depending on the setting of the speaker pattern.

xPhase Audio

• OFF

• FL/FR, FL/CNT, CNT/FR, FR/SL, FR/SR, SR/SL, SR/SBR, SBR/SBL, SR/SB, SBL/ SL, SB/SL, SL/FL, FL/SR

Lets you output front 2 channel source sound (instead of the test tone) sequentially from adjacent speakers.

Some items may not be displayed, depending on the setting of the speaker pattern.

Other parameters of Speaker settings menu

xBI-AMP Speaker

• OFF

If you have not connected surround back speakers, select “OFF”.

• ON

If you connect front speakers in a bi- amplifier configuration, select “ON”.

Note

Set “BI-AMP Speaker” to “OFF”, then connect the

 

surround back speakers to this receiver when you

 

want to change the connection from a bi-amplifier

 

connection to a surround back speakers connection.

 

Re-set up the speakers after you connect the

 

surround back speakers. Refer to “Auto Calibration”

Advanced

(page 44) or “Manual Setup” (page 67).

 

x Crossover Freq

(Speaker crossover frequency)

Lets you set the bass crossover frequency of

Speakers

speakers that has been set to “SMALL” in the

 

Speaker menu. Measured speaker crossover

 

frequency is set for each speaker after the Auto

 

Calibration.

Setting

The adjusted value is set for each speaker

 

when you adjust the speaker crossover

 

frequency using “Crossover Freq” after the

Up

Auto Calibration.

 

continued

71US