Programming the remote

You can customize the remote to match the components connected to your receiver. You can even program the remote to control non- Sony components and also Sony components that the remote is normally unable to control. The procedure below uses as an example a case in which a VCR made by a company other than Sony is connected to the VIDEO 1 IN jacks on the receiver.

Before you begin, note that:

–You cannot change the settings of PHONO.

–The remote can control only components that accept infrared wireless control signals.

Be sure to turn on the receiver and point the remote towards the receiver when performing the following procedure.

1

 

THEATER

 

 

 

 

SHIFT

TV

AMP

 

 

1

2

3

 

 

VIDEO 1

VIDEO 2

BD

 

2,3

4

5

6

 

7

8

9

 

 

DVD

SAT

TV

 

 

MD/

SA-CD/

TUNER

 

 

TAPE

CD

 

 

 

4

 

-/--

0/10

ENT/MEM

 

PHONO

MULTI IN

DMPORT

 

CLEAR/>10

 

 

 

 

XM

SIRIUS

 

 

2CH/

A.DIRECT A.F.D. MOVIE MUSIC

1 Press AV ?/1 while pressing RM

SET UP.

The RM SET UP indicator slowly flashes.

2 Press the input button (including TV) for the component you want to control.

For example, if you are going to control a CD player, press SA-CD/CD.

The RM SET UP and the SHIFT button indicator light up.

If you press the button for a component of which you cannot program the remote, such as DMPORT, XM or SIRIUS, etc., the RM SET UP indicator keeps flashing.

3 Press the numeric buttons to enter the numeric code (or one of the codes if more than one code exists) corresponding to the component and the maker of the component you want to control.

See the tables on page 121–124 for information on the numeric code(s).

Note

For a TV remote code value, only numbers in the 500’s are valid.

4 Press ENT/MEM.

Once the numeric code has been verified, the RM SET UP indicator slowly flashes twice and the remote automatically exits the programming mode.

5 Repeat steps 1 to 4 to control other components.

Notes

•The indicator turns off while a valid button is pressed.

•In step 2, if you press TUNER, you can only program the button to control a tuner (page 124).

•In step 2, if you want to change to other input, press SHIFT and then press the new input buttons you want.

•For the numeric codes, only the last three numbers entered are valid.

120US