Timer recording radio programmes (continued)

4 Set the time to start recording.

Press .or >repeatedly to set the hour, then press ENTER/YES.

The minute indication flashes.

Press .or >repeatedly to set the minute, then press ENTER/YES.

The hour indication flashes again.

5 Set the time to stop recording following the procedure in step 4.

“OFF TIME NG” appears if the start time and the stop time settings are the same. Change the stop time.

6 Press .or > repeatedly to select the recording source, then press ENTER/YES.

The indication changes as follows:

When recording on a tape

tTUNER c TAPE

r

AUX* c TAPE

When recording on an MD with the optional MD deck MDS-SP55

tTUNER c MD r

TUNER c MD (M)**

r

AUX c MD

r

AUX c MD (M)

*You can select the connected component for recording source. Set the timer on both systems to the same time.

**When you record onto an MD in monaural format.

When you press ENTER/YES, the start time, stop time and other setting contents appear in turn, then the original display returns.

“REC” lights up.

Note

You cannot activate another MD deck (except for the optional MD deck MDS-SP55) with this system’s recording timer.

7 Insert a blank tape.

8 Press ?/1 to turn off the system.

To cancel the procedure

Press CLOCK/TIMER SET.

To change the setting

Start over from step 1.

To check the setting/activate the timer

Press CLOCK/TIMER SELECT and press . or > repeatedly until “SEL TAPE REC” (or “SEL MD REC” when using the optional MD deck MDS-SP55) appears. Then press ENTER/ YES.

It is not necessary to set the start and stop times every time.

To cancel the timer

Press CLOCK/TIMER SELECT and press . or > repeatedly until “TIMER OFF” appears. Then press ENTER/YES.

32