Optional Components

There is no sound.

•Refer to General item “There is no sound.” on page 39 and check the condition of the system.

•Connect the component properly (see page

34)while checking:

–if the cords/cables are connected properly.

–if the cord/cable connectors are firmly inserted all the way.

•Turn on the connected component.

•Refer to the operating instructions included with the connected component and start playing.

The sound is distorted.

• Attenuate the distortion (see page 35).

The sound from the component connected to the AUX IN jacks is not heard.

•Turn FUNCTION until “AUX” appears.

•Connect the audio cord securely.

If the system still does not operate properly after performing the above measures, reset the system as follows:

1Unplug the mains lead.

2While holding down @/1, connect the mains lead to the mains.

The system is reset to the factory settings. All the settings you made such as the preset stations, clock, timer and CD disc titles are cleared. You should set them again.

Messages

One of the following messages may appear or flash in the display during operation.

CD

Name Full

There are already 50 disc titles stored in the system.

- OVER -

You have reached the end of the CD while keeping pressing ML on the CD player during pause.

Cannot Edit

You tried to label a CD TEXT disc.

TAPECannot SYNC

•There is no tape in the tape deck, or the tab has been removed from the cassette.

•The tabs and the direction setting do not match.

No TAB

You cannot record the tape because the tab has been removed from the cassette.

No Tape

There is no tape in the tape deck.

Information Additional

41