Sony CPD-L133 Power Saving Function, Displaying the INFORMATION, OSD, Plug & Play, Note, mode, NUTEK, Screen, Example, Vertical, Horizontal, Model name, u Indicator

Power Saving Function

This monitor meets the power-saving guidelines set by VESA and ENERGY STAR, as well as the more stringent

NUTEK .

If the monitor is connected to a computer or video graphics board that is VESA DPMS (Display Power Management Signaling) compliant, the monitor will automatically reduce power consumption in three stages as shown below.

Technical Features

You can set the delay time before the monitor enters the power saving mode using the OSD. Set the time according to “Setting the Power Saving Delay Time” on page 14.

Note

If no video signal is input to the monitor, the “NO INPUT SIGNAL” message (page 18) appears. After the delay time has passed, the power saving function automatically puts the monitor into the active-off mode and the u indicator lights up orange. Once the horizontal and vertical sync signals are detected, the monitor automatically resumes its normal operation mode.

	Power consumption	Screen	Horizontal	Vertical	Power consumption			Recovery time	u Indicator
	mode		sync signal	sync signal
1	Normal operation	active	present	present	CPD-L133 ≤ 30 W*		≤ 42 W**	—	Green
					CPD-L150 ≤ 25 W*		≤ 35 W**
2	Standby (1st mode)	blank	absent	present	CPD-L133 ≤ 1.5 W*		≤ 4 W**	Approx. 3 sec.	Green and orange
					CPD-L150 ≤ 1.5 W*		≤ 4 W**		alternate
3	Suspend (2nd mode)	blank	present	absent	CPD-L133 ≤ 1.5 W* ≤ 4 W**			Approx. 3 sec.	Green and orange
					CPD-L150 ≤ 1.5 W*		≤ 4 W**		alternate
4	Active-off (3rd mode)	blank	absent	absent	CPD-L133 ≤ 1.5 W*		≤ 4 W**	Approx. 10 sec.	Orange
					CPD-L150 ≤ 1.5 W* ≤ 4 W**					EN
5	Power-off	––	––	––	CPD-L133 ≤ 1.5 W* ≤ 4 W**			—	Off
					CPD-L150 ≤ 1.5 W* ≤ 4 W**
										F
* Power consumption of the monitor only
										D
** Power consumption of the monitor including the AC adaptor
										ES
										I
Displaying the INFORMATION						Plug & Play
OSD					This monitor complies with the DDC™1 and DDC2B
You can confirm the name, the serial number and the year					Display Data Channel (DDC) standards of VESA.
					When a DDC1 host system is connected, the monitor
of manufacture of this monitor.
					synchronizes with the V. CLK in accordance with the VESA
Press and hold the MENU button for five seconds.					standards and outputs the EDID (Extended Display
					Identification Data) to the data line.
The INFORMATION OSD appears.
	MENU				DDC™ is a trademark of the Video Electronics Standard
					Association.
Example
	INFORMATION		Model name
	MODEL : CPD-L150
			Serial number
	SER. NO : 1234567
	MANUFACTURED : 1998		Year of manufacture

The INFORMATION OSD automatically disappears after about 30 seconds.

To close the OSD, press the MENU button again.

17