Note on placing speakers
Use caution when placing the subwoofer or front/rear speakers on a specially treated (waxed, oiled, polished, etc.) floor, as staining or discoloration may result.
Specifying the speaker parameters
To obtain the best possible surround sound, set the size of the speakers you have connected and their distance from your listening position. Then use the test tone to adjust the level and the balance of the speakers to the same level.
Select “SPEAKER SETUP” in the setup display. For details, see “Using the Setup Display” (page 69).
The default settings are underlined.
SPEAKER SETUP
SIZE:
DISTANCE:
LEVEL:
BALANCE:
CONNECT:
TEST TONE:
To return to the default setting
Select the item, then press CLEAR.
xSIZE
If you do not connect center or rear speakers, or move the rear speakers, set the parameters for CENTER and REAR. Since the front speaker and subwoofer settings are fixed, you cannot change them.
FRONT | YES |
|
|
CENTER | YES: Normally select this. |
| NONE: Select this if no center speaker is used. |
REAR | BEHIND, SIDE: Specify the position and height to implement the Digital |
| Cinema Surround modes. |
| NONE: Select this if no rear speaker is used. |
SUBWOOFER | YES |
|
|
Notes
•When you select an item, the sound cuts off for a moment.
•Depending on the settings of other speakers, the subwoofer may output excessive sound.
continued
Started Getting