Note

•The ECM-AC2 jack is used for the supplied calibration microphone only. Do not connect other microphones.

Rear of the control unit

To ECM-AC2 jack

Calibration microphone

10 Press C/c to select [YES].

Note

•Make sure that the headphones are not connected to the surround amplifier (page 74). You cannot operate following steps with the headphones connected.

•Before [AUTO CALIBRATION], be sure that the surround amplifier turns on and you install the surround amplifier in the appropriate location. If you install the surround amplifier in an improper location, such as another room, proper measurement will not be obtained.

11 Press .

[AUTO CALIBRATION] starts. Be quiet during the measurement.

Note

•Loud test sound is output when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbours.

•Avoid being in the measurement area and making noise during the measurement (which takes about 1 minute), as it may interfere with measurement.

12 Unplug the calibration microphone and press C/c to select [YES].

Note

•The environment of the room in which the system is installed may affect measurements.

•If measurement fails, follow the message then retry [AUTO CALIBRATION].

13 Press .

Quick Setup is finished. All connections and setup operations are complete.

To quit the Quick Setup

Press DISPLAY in any Step.

Tip

•If you cancel [AUTO CALIBRATION], perform the speaker settings in “Settings for the Speakers” (page 96).

•If you change the position of the speakers, reset the speaker settings. See “Calibrating the Appropriate Settings Automatically” (page 88).

•If you want to change any of the settings, see “Using the Setup Display” (page 90).

•For details on [AUTO CALIBRATION] and the error messages of [AUTO CALIBRATION], see “Calibrating the Appropriate Settings Automatically” (page 88).

continued

Started Getting

35GB