Connecting your camcorder to your computer – Introduction
To confirm the USB driver installation
1Click [Start] t [Settings] t [Control Panel].
2Click [System].
“System Properties” screen appears.
3Click [Hardware] tab.
4Click [Device Manager].
“Device Manager” screen appears.
5Make sure that “SONY
When all the devices appear, the USB driver is installed correctly. If any of these devices are not shown, install the USB driver again following “If you cannot install the USB driver” (page 97).
1 | Connect the AC adaptor to your | |
2 | camcorder. |
|
Set the mode dial to | (Play/Edit). | |
3 | Turn the power on your camcorder by | |
| sliding the POWER switch upward | |
| while pressing the green button. | |
4 | Connect the (USB) jacks of the | |
| camcorder and the | (USB) port of the |
computer using the USB cable supplied with your camcorder.
USB port
USB cable
USB jack
Your computer recognises the camcorder, and the “New Hardware Found” dialog box appears.
5 Follow the instructions given in the on- screen messages and restart your computer.
The connection between your camcorder and the computer is completed.
computer your on recordings the editing discs/ Viewing/dubbing