Identifying parts and controls (Continued)

Remote Commander (DCR-DVD710/ DVD810)

screen. Select a desired button or an item with

b/ B / v / V, then press ENTER to enter.

bNotes

Remove the insulation sheet before using the Remote Commander.

Insulation sheet

Point the Remote Commander towards the remote sensor to operate your camcorder (p. 131).

When no commands have been sent from the Remote Commander in a certain period, the orange frame disappears. When you press any of b / B / v / V, or ENTER again, the frame appears at the position where it was displayed last.

You cannot select some buttons on the LCD screen using b / B / v / V.

ADATA CODE button (84)

Displays the date and time or camera setting data of the recorded images when you press this during playback.

BPHOTO button (34, 39)

The on-screen image when you press this button will be recorded as a still image.

CSCAN/SLOW buttons (35, 44)

D. > (Previous/Next) buttons (35, 44)

EPLAY button (35, 44)

FSTOP button (35, 44)

GDISPLAY button (22)

HTransmitter

ISTART/STOP button (34, 39)

JPower zoom buttons (40, 46)

KPAUSE button (35, 44)

LVISUAL INDEX button (35, 43)

Displays a VISUAL INDEX screen when you press this during playback.

Mb / B / v / V / ENTER buttons

When you press any button on the VISUAL INDEX/Face Index/Film Roll Index/Playlist screen, the orange frame appears on the LCD

To change the battery of the Remote Commander

1While pressing on the tab, inset your fingernail into the slit to pull out the battery case.

2Place a new battery with the + side facing up.

3Insert the battery case back into the Remote Commander until it clicks.

Tab

WARNING

Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.

When the lithium battery becomes weak, the operating distance of the Remote Commander may shorten, or the Remote Commander may not function properly. In this case, replace the battery with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or explosion.

132

Page 132
Image 132
Sony manual 132, Remote Commander DCR-DVD710/ DVD810, To change the battery of the Remote Commander, Data Code button