— Playback – Basics —

Playing back a tape

You can monitor the playback picture on the LCD screen. If you close the LCD panel, you can monitor the playback picture in the viewfinder. You can also control playback using the Remote Commander supplied with your camcorder.

(1) Install the power source and insert a recorded tape.

(2) Press OPEN to open the LCD panel.

(3) Set the POWER switch to VCR. The camcorder turns on and the VCR lamp lights up.

(4) Select, then press the center z on the control button to rewind the tape.

(5) Select , then press the center z on the control button to start playback.

(6) Adjust the volume following the procedure below.

1Select FN, then press the center z on the control button. The PAGE1 screen appears.

2Select VOL, then press the center z on the control button. The screen used for adjusting the volume appears.

3Select –/+, then press the center z on the control button repeatedly to adjust the volume.

–: to turn down the volume +: to turn up the volume

You can adjust the volume by pressing b/B repeatedly after you select –/+.

(7) Select

OK, then press the center z on the control button. The PAGE1 screen

appears.

 

Basics – Playback

4 5 6

FN

OK

– VOL +

VOL bar

2

3 POWER

CAMERA

MEMORY/

(CHG)

NETWORK

OFF

VCR

ON

 

MODE

1

39