On handling the casing

If the casing is soiled, clean the camcorder body

with a soft cloth lightly moistened with

water,

and then wipe the casing with a dry soft

cloth.

Avoid the following to avoid damage to the finish:

Using chemicals such as thinner, benzine, alcohol, chemical cloths, repellent, insecticide and sunscreen

Handling the camcorder with above substances on your hands

Leaving the casing in contact with rubber or vinyl objects for a long period of time

About care and storage of the lens

Wipe the surface of the lens clean with a soft cloth in the following instances:

When there are fingerprints on the lens surface.

In hot or humid locations

When the lens is exposed to salty air such as at the seaside.

Store in a well-ventilated location subject to little dirt or dust.

To prevent mold, periodically clean the lens as described above. It is recommended that you operate your camcorder about once a month to keep it in optimum state for a long time.

On charging the pre-installed rechargeable battery

Your camcorder has a pre-installed rechargeable battery to retain the date, time, and other settings even when the POWER switch is set to OFF (CHG). The pre-installed rechargeable battery is always charged while your camcorder is connected to the wall outlet (wall socket) via the

AC Adaptor or while the battery pack is attached. The rechargeable battery will be fully discharged in about 3 months if you do not use your camcorder at all. Use your camcorder after charging the pre-installed rechargeable battery.

However, even if the pre-installed rechargeable battery is not charged, the camcorder operation will not be affected as long as you are not recording the date.

Procedures

Connect your camcorder to a wall outlet (wall socket) using the supplied AC Adaptor, and leave it with the POWER switch set to OFF (CHG) for more than 24 hours.

94

Page 94
Image 94
Sony DCR-SR65 manual On handling the casing, About care and storage of the lens,  Procedures