Sony DXC-990 Connecting Two or More Cameras — Multi-CameraSystem, -Adjust the subcarrier and horizontal synchronization phases for all cameras

Connecting Two or More Cameras — Multi-Camera System

							1 Set the MODE selector to
Sync signal generator							2	the [1] position.
Sync	75-ohm coaxial cable					CMA-D2/
						D2MD/D2CE/
(VBS or						D2MDCE
BS) output						camera
connector						adaptor
		DXC-990/990P						CAMERA
								(12-pin)	Power
		MENU		BLACK
		TRIG IN	FILE		BARS				cord
			SELECT	WHITE
					ENTER
		RGB/SYNC				GEN LOCK IN
				LENS	MENU LOCK
					ON
	VIDEO	OUT			OFF
	OUT T	DC IN/		GEN
		VBS
			REMOTE
VBS	VIDEO				DC IN/		CCMC-12P02/05/
OUT	IN
Switcher, etc.			VBS T				10/25 cable
VIDEO	VBS OUT						1	Set the MODE selector to
IN	75-ohm coaxial cable						2	the [1] position.
							CMA-D2/D2MD/
							D2CE/D2MDCE
							camera adaptor
		DXC-990/990P
		MENU	SELECT	WHITE				CAMERA
				BLACK
		TRIG IN	FILE		BARS
		RGB/SYNC			ENTER			(12-pin)
Video input				LENS	MENU LOCK
					ON
connector	VIDEO	OUT DC IN/		GEN LOCK		GEN LOCK IN			Power
		VBS			OFF
	OUT T		REMOTE						cord
Video monitor,		DC IN/		CCMC-12P02/05/10/25 cable
VCR, etc.
	VBS T

Notes

•Perform the following to synchronize the picture tone of the cameras when switching between two or more cameras connected to a video switcher:

-Supply the same sync signal to the GEN LOCK IN connectors on the cameras.

-Adjust the subcarrier and horizontal synchronization phases for all cameras.

For more details, see “Adjusting the Picture Tone in a Multi-Camera System” on page 25.

•Turn on the power of the sync signal generator after all other equipment is switched on.

Connections and Installation

Connections 31 GB