Sony DXC-990 RGB SYNC, BAUD RATE, D-SUBOUT, D-SUBVIDEO, SYNC, D-SUB, OFF, C. SYNC, WEN (WEN 1-3)

Note

When TRIGGER in the GENERAL menu is set to OFF, D-SUB SYNC is always set to WEN and you cannot select a different phase.

POLARITY

Selects the polarity of the pulse signal.

: Negative

: Positive

Note

When the CMA-D3/C3CE is connected to the camera with the CCMC-3MZ connecting cable, you cannot select C. SYNC.

RGB SYNC

Adds a sync signal to the G signal or R, G and B signals output from the RGB/SYNC connector.

OFF

No sync signal is added to an output signal.

Selects the sync signal output from the RGB/

SYNC connector (D-sub9-pin).

The SYSTEM menu is used to set the items relating to the system of the camera and

selection of output signals.C. SYNC

Outputs the composite sync signal.

SYSTEM Menu

D-SUB SYNC

<SYSTEM>						[A]
>BAUD RATE						9600
	D-SUB OUT					R/G/B	WEN (WEN 1-3)
	D-SUB VIDEO					VBS	Outputs the WEN signal. When connecting
	D-SUB SYNC				C.SYNC
	RGB SYNC					G	peripheral equipment, the signal is used as
	12P CONNECTOR					IN	trigger pulse output to the equipment.
							Switching WEN 1 to 3 provides a different
		Select		Back			pulse signal phase.
			MENU

	For the timing chart of the WEN pulse signal
	for each setting, see page 39.
BAUD RATE

Switches the baud rate of the REMOTE

connector.

Sets to any of19200, 9600, 4800, 2400 and1200.

Set to 9600 when the RM-C950 remote control unit is connected.

Note

When the CMA-D3/C3CE is connected to the camera using the CCMC-3MZ connecting cable,“CMA-D3” will appear

and you cannot select the baud rate.

D-SUB OUT

Selects the RGB (R/G/B) or componentY/(

CR/CB) signal output from the RGB/SYNC connector (D-sub 9-pin).

D-SUB VIDEO

Selects theVBS orY/C signal output from

the RGB/SYNC connector (D-sub 9- pin).

G

Note Adds a sync signal to the G signal output

When the CMA-D3/C3CE is connected to from the RGB/SYNC		connector.
the camera with the CCMC-3MZ connecting
cable, the item does not function.
GB 20	SYSTEM Menu