Turn this ring to focus the lens on the subject.
2Zoom ringFor direct manual zoom control, set the ZOOM selector 7 to the “MANU.” position, and turn this ring.
3Aperture ringFor manual aperture control, set the IRIS selector qd to the “M” position, and turn this ring.
4MFor
F.B adjustment ring : To adjust the flange focal length, loosen the F.B fixing knob, then turn the ring. (See page 82.)
F.B fixing knob: Fixes the F.B adjustment ring.
6MACROFor
This selects the mode of zoom operation.
SERVO: power zoom
MANU. (manual): manual zoom8Zoom remote control connector
When operating with a VTR: this button starts and stops recording, and once more to stop.
When operating with a
connects the return video signal from the camera control unit to the viewfinder.
(Starting and stopping recording is controlled on the VTR.)
When operating with a
connects the intercom audio signal from the camera to the camera control unit.
Use this button for the shuttle shot function.
qa RET (return video) buttonThis allows you to check the video signal as follows.
When operating with a portable VTR connected via other equipment: when the VTR is in
recording, pressing this button connects the
When operating with a
recording pause mode, press this button to review the last few seconds of the recording in the viewfinder (recording review).
When operating with a
pressing this button connects the return video signal from the camera control unit to the viewfinder.
When this button is not pressed, the viewfinder displays the video signal captured by the camera.
qs Motorized zoom leverUse this to carry out a power zoom. Pressing the lever harder increases the zoom speed.
W end: zoom toward wide angle
T end: zoom toward telephoto
qd IRIS selectorThis selects the mode of aperture operation. A (automatic): automatic aperture
M (manual): manual aperture
qf Instant automatic aperture adjustment button While using manual aperture control, press this button to switch temporarily to the automatic aperture control setting. The automatic setting is maintained as long as you hold the button down.
qg DIP switchThe DIP switch for the shuttle shot function. Usually this switch is covered by a rubber cap.
qh Aperture gain adjustment trimmerUse this to adjust the aperture gain. Usually the trimmer is covered by a rubber cap.
qj Shuttle memory position setting knobUse this button for the shuttle shot function.
Overview 1 Chapter
..........................................................................................................................................................................................................
1) | internal electrical circuits, but has not been converted to |
This is the input video signal which has passed through | a magnetic signal. |
Chapter 1 Overview 19