Sony FS-2570 Scan Channel Groups, Editing/Deleting user channels, Registering scan channel groups

9 NBDP PREPARATIONS

8. To quit, press the [Esc] key.

9.4.2 Editing/Deleting user channels

1.Press function key [F5] and then the [4] key.

2.Press the [↑] or [↓ ] key to choose channel from the Channel List.

3.Press [→ ] and [↓ ] keys to choose Change and press the [Enter] key.

4.Do one of the following:

Edit channel: Use [↑ ], [↓ ] and the [Backspace] key to make modifications.

Delete channel: Erase channel number with the [Backspace] key.

5.Press the [Enter] key twice.

6.Press the [Esc] key.

9.5 Scan Channel Groups

You may store up to 10 scan groups, 20 channels per group. Note that scanning is only possible in the ARQ and FEC-collective modes.

The NBDP Terminal Unit can automatically control radio equipment through channel scanning. The radio equipment scans a number of channels (according to your selection), stopping when an incoming signal is found. In the ARQ mode it stops when your own ID code is detected in an incoming signal. Also, in the ARQ mode, the transmitter is then tuned to the corresponding transmitter frequency, the communication link is established and the traffic is automatically exchanged. Scanning resumes once the link is disconnected.

9.5.1 Registering scan channel groups

You may register ITU and user scan channels as follows:

1. Press the function key [F5] followed by the [3] key to display the Scan Entry screen.

Scan Entry

Scanning Group List

Create

Change

				Scanning Set Up
	Group Name		: _
	Ch Dwell Time		: 4.5 sec (2.7-4.5 sec)
	Mode		: AUTO ARQ FEC
	Auto Search		: OFF ON
	No	Channel	Rx Freq		Tx Freq	Pass/Scan
0						Pass/Scan
1						Pass/Scan
2						Pass/Scan
3						Pass/Scan
4						Pass/Scan
▼ 5

Scan entry screen

2. If Create is not underlined, press [→ ], [↑ ] and the [Enter] key to underline it.

9-7

offered by Busse-Yachtshop.de email: info@busse-yachtshop.de