Plug & Play
This monitor complies with the DDC™1, DDC2B and DDC2AB which are the Display Data Channel (DDC) standards of VESA.
When a DDC1 host system is connected, the monitor synchronizes with the V. CLK in accordance with the VESA standards and outputs the EDID (Extended Display Identification Data) to the data line.
When a DDC2B or DDC2AB host system is connected, the monitor automatically switches to each communication.
DDC™ is a trademark of Video Electronics Standard Association.
Damper Wire
Using a white background, very thin horizontal lines on the screen are visible as shown below. These lines are damper wires.
The Trinitron tube has a vertically striped Aperture Grill inside. The Aperture Grille allows more light to pass through to the screen giving the Trinitron CRT more color and brightness.
These damper wires are attached to the Aperture Grille to prevent vibration of the Aperture Grille wire so that the screen image is constantly stable.
Damper wire
Power Saving
Function
This monitor is capable of three states of reduced power consumption. By sensing the absence of video signals and one or both sync signals coming from the host computer, it will reduce power consumption as follows.
| Power | Power | Recovery | power | u power |
| consumption | consump- | time | saving | indicator |
| state | tion |
| indicator |
|
1 | Normal | ≤ 200 W | — | Off | Green on |
| operation |
|
|
|
|
2 | Standby | ≤ 140 W | Approx. | Orange on | Green on |
| (1st state) |
| 3 sec. |
|
|
3 | Suspend | ≤ 15 W | Approx. | Orange on | Green on |
| (2nd state) |
| 3 sec. |
|
|
4 | ≤ 8 W | Approx. | Orange on | Off | |
| (3rd state) |
| 10 sec. |
|
|
5 | 0 W | — | Off | Off |
Power saving operation
∙The
/The unit goes into standby state.
∙The
/The unit goes into suspend state.
∙Both the
/The unit goes into
The monitor requires a video card or screen saver software which switches off one or both sync signals to activate the power saving function.
Caution
If no video signal is input to the monitor, or if the input select switch is set to the connector to which no signal is input when you turn on the monitor, the input signal warning indicator (page 17) appears. After 30 seconds, the Power Saving function automatically puts the monitor into the 
power saving indicator lights up. Once the horizontal and vertical syncs are sensed, the monitor will automatically return to its Normal operation state.
16
