Input Signal Warning Function
If there is something wrong with the input signal, one of the following messages appears when you turn the monitor off and on, or when you operate the input select switch.
The message disappears after about 30 seconds.
PLEASE CHECK THE S I GNAL
I NPUT : 1 | _ Hz |
FH :84.4kHz FV : |
1Shows the input select switch setting.
2Shows the input signal condition.
“FH: - kHz” indicates no horizontal sync signal.
“FV: - Hz” indicates no vertical sync signal.
“OUT OF SCAN RANGE” indicates that the input signal is not supported by the monitor’s specifications.
“NO CONNECTION” indicates that the supplied video
signal cable is disconnected from the HD15 connector when the input select switch is set to k.
Use of the Tilt-
Swivel
With the
To turn the unit vertically and horizontally, hold it at its bottom with both hands as illustrated below.
155°
15°
155°
5°
Specifications
|
|
|
| EN |
|
|
|
| |
Picture tube | 0.25 – 0.28 mm aperture grille pitch |
| F | |
| 24 inches measured diagonally |
|
| |
|
| D | ||
Viewable image size | Approx. 482 × 304 mm (w/h) |
| ||
| (19 × 12 inches) |
|
| |
| 22.5” viewing image |
| ES | |
Resolution | Horizontal: Max. 1920 dots |
|
| |
| Vertical: Max. 1200 lines |
| I | |
Standard image area | Approx. 473 × 296 mm (w/h) |
| ||
|
| |||
| (18 5/8 × 11 3/4 inches) |
| J | |
Deflection frequency | Horizontal: 30 to 96 kHz |
| ||
| Vertical: 50 to 160 Hz |
|
| |
Input | HD15 (1), 5 BNC (1) |
| ||
| R/G/B: 75 Ω, 0.714 |
| ||
| HD/VD or Composite sync |
| ||
|
| |||
| negative |
| ||
AC input voltage/current |
| |||
| 100 to 120 V, 50/60 Hz, 2.2 A |
| ||
| 200 to 240 V, 50 – 60 Hz, 1.4 A |
| ||
Power consumption | Max. 200 W |
| ||
Dimensions | 580 × 500 × 548 mm (w/h/d) |
| ||
| (22 7/8 × 19 3/4 × 21 5/8 inches) |
| ||
Mass | Approx. 41 kg (90 lb 6 oz) |
| ||
Design and specifications are subject to change without notice.
17
