Troubleshooting (Continued)

You cannot dub correctly using the HDMI cable.

• You cannot dub images using the HDMI cable.

You cannot dub correctly using the A/V connecting cable.

•The A/V connecting cable is not connected properly. Make sure that the A/V connecting cable is connected to the proper jack, i.e. to the input jack of another device for dubbing a image from your camcorder (p. 58).

Prints cannot be made using a PictBridge printer.

•Your printer may not print images edited on a computer or recorded using other devices. This is not a malfunction.

Others

Unable to clip a still image from a movie on the hard disk of your camcorder.

• You cannot clip a still image from a movie stored on your camcorder.

The beep sounds for 5 seconds.

•The temperature of your camcorder is extremely high. Turn off your camcorder and leave it for a while in a cool place.

•Some problems have occurred in your camcorder. Turn off, and on, then operate your camcorder again.

•The temperature of your camcorder is extremely low. With POWER switch turned on, leave the camcorder for a while. If you still cannot operate the camcorder, turn it off, taking it to a warm place. Leave the camcorder there for a while, then turn on the camcorder.

Connecting to a computer

A computer does not recognize your camcorder.

•Install Picture Motion Browser (p. 87).

•When you connect your camcorder to a computer for the first time, it may take some time for the computer to recognize the camcorder. Wait for a while.

•Disconnect the USB device other than the keyboard, the mouse, and the camcorder from the computer.

•Disconnect the cable from the computer and camcorder, restart the computer, then connect them again correctly.

Cannot use the supplied software, Picture Motion Browser, on the Macintosh computer.

• You cannot use Picture Motion Browser on a Macintosh.

100