Parts of Function and Location 2 Chapter
8REC INHI (recording inhibit) indicator
This indicator is on or off according to the combination of the F5 (RECINH) setting on function menu page 4 and the record inhibit plug on the cassette, as shown in the following table. When this indicator is on, recording on tape is prohibited.
REC INHI indicator indications
RECINH setting | State of the record | REC INHI |
| inhibit plug on the | indicator state |
| cassette |
|
ON | Record inhibit/permit | Lit |
|
|
|
OFF | Record inhibit | Lit a) |
| Record permit | Off |
|
|
|
a)It is possible to make a setting (setup menu item 107) so that in this case the indicator flashes.
9Tape transport control section
1PREROLL button
2 REC button
PREROLL | REC |
| 3 EDIT button |
| EDIT | ||
| STANDBY | ||
|
|
| |
|
|
| 4 STANDBY button |
REW | PLAY | F FWD | STOP |
|
| ||
|
|
| 5 STOP button |
6 F FWD button
7PLAY button
8SERVO indicator
9REW button
1PREROLL button
Press this button to cue up to the preroll point (before the IN point by the time set as the preroll time) on the tape. You can change or select the preroll time and the state of the unit at the end of preroll (“stop mode” 1) or still playback mode) using setup menu item 001 or 401.
Cuing up edit points
Hold down the IN, OUT, AUDIO IN, or AUDIO OUT button while pressing this button to cue up to the corresponding edit point.
2REC (record) button
To start recording, press this button together with the PLAY button, turning it on.
Monitoring in
When the unit is in stop mode, pressing the REC button lights the button and allows you to monitor the video and audio in
During playback, search, fast forward, or rewind, holding down the REC button allows you to monitor the video and audio in
3EDIT button
To carry out manual editing, press this button simultaneously with the PLAY button.
Monitoring in
When the unit is in stop mode, pressing the EDIT button lights the button and allows you to monitor the input signal selected with the ASSEMBLE button or INSERT buttons in
During playback, search, fast forward, or rewind, holding down the EDIT button allows you to monitor the video and audio input signals in
4STANDBY button
When this button is off with a cassette inserted in the unit, to put the unit in standby mode, press the button, turning it on.
In standby mode, the drum is rotating and the tape is in contact with the drum. As a result, recording or playback can start immediately.
To end standby mode, press the STANDBY button, turning it off.
If 8 minutes (value can be varied using setup menu item 501) elapse in standby mode, the unit automatically switches out of standby mode to protect the tape.
..........................................................................................................................................................................................................
1)Stop mode: The state in which the device currently the subject of operation is stopped, and the STOP button is lit.
Chapter 2 Location and Function of Parts |