Parts of Function and Location 2 Chapter

2-2 Connector Panel

1REMOTE 2 PARALLEL I/O(50P) connector (D-sub 50-pin)

Connect remote control signals from an external device.

For details, refer to the Installation Manual.

2CONTROL PANEL connector (round type, 10- pin)

In addition to the lower control panel, a similar control panel can be connected to this unit. To connect such a second control panel, use this connector. When two control panels are connected, use the PANEL SELECT switch on the switch panel (see page 2-14)to specify which control panel will control this unit.

3VIDEO CONTROL(15P) connector (D-sub 15- pin)

For remote control of the internal digital video processor, connect an optional BVR-50/50P Video Remote Control Unit.

Always power off this unit before connecting the remote control unit.

4VIDEO CONTROL(9P) connector (D-sub 9-pin) For remote control of the internal digital video processor, connect an optional HKDV-900 Video Remote Control Unit.

Always power off this unit before connecting the remote control unit.

5 REMOTE 1-IN(9P) connector (D-sub 9-pin)

When using this unit together with another HDCAM

VTR, and a BVE-series BVE-700/900/910/2000/9000/

9000P/9100/9100P or other editor, connect the

optional 9-pin remote control cable from the other unit

to this connector.

Depending on the setting of setup menu item 211, you

7RS-232C connector (D-sub 9-pin)

Use this for monitoring and diagnosis of the state of this unit from an external computer, using the ISR (Interactive Status Reporting) function.

7Time code input/output section

1 TIME CODE IN connector

TIME CODE

INOUT

2 TIME CODE OUT connector

1TIME CODE IN connector (XLR 3-pin, female) To record time code from an external device, input a time code signal from the time code output connector of the other device.

2TIME CODE OUT connector (XLR 3-pin, male) This outputs a time code according to the operating state of the unit, as follows:

•During playback: the playback time code

By setting setup menu item 606, you can also output the time code from the internal time code generator locked to the playback time code.

•During recording: the time code generated by the internal time code generator or the time code input to the TIME CODE IN connector.

8 Audio monitor signal output section

can use this connector alone, or in a loop-through

configuration with the REMOTE 1-OUT(9P)

connector.

MONITOR OUTPUT

RL

1 MONITOR OUTPUT R connector

6REMOTE 1-OUT(9P) connector (D-sub 9-pin) This provides the loop-through output for remote control signals from the REMOTE 1-IN(9P) connector.

Depending on the setting of setup menu item 211, you can use this connector alone, or in a loop-through configuration with the REMOTE 1-IN(9P) connector.

2 MONITOR OUTPUT L connector

2-18

Chapter 2 Location and Function of Parts