Parts of Function and Location 2 Chapter

2-1 Control Panels

2-1-3 Switch Panel

To access the switch panel, open the lower control

On how to open the lower control panel, see the figure on

panel.

page 2-1.

1Memory card slot

2 Memory card ejection button

3 CONTROL PANEL connector

CONTROL PANEL

KEY INHI

PANEL SEL

ON OFF REAR FRONT

4 PANEL SELECT switch

5KEY INHIBIT switch

6Memory stick slot

1Memory card slot

Insert a memory card to update this unit’s firmware. You can save or load setup menu settings onto the memory card.

For details on firmware update and setup menu reading/ storing, refer to the Maintenance Manual Volume 1.

REAR: Enables the control panel connected to the CONTROL PANEL connector on the connector panel. When setup menu item 117 is set to PARA, this switch position also enables the control panel connected to the CONTROL PANEL connector on the switch panel.

2Memory card ejection button

Press to eject a memory card from the memory card slot.

3CONTROL PANEL connector (10-pin, round type)

Plug in the lower control panel connection cable.

4PANEL SELECT switch

In addition to the lower control panel, you can connect a similar control panel to this unit. When two control panels are connected to the unit, the PANEL SELECT switch is used to specify which panel be enabled to control the unit.

FRONT: Enables the control panel connected to the CONTROL PANEL connector on the switch panel.

5KEY INHIBIT switch

Moving this switch to the ON position disables the controls on the upper and lower control panels.

You can specify which buttons and knobs are disabled in setup menu item 118.

6Memory stick slot

Use this to update the firmware. You can also save or load setup menu settings onto the memory stick.

Note

After inserting a memory stick or memory card, allow at least five seconds to elapse before removing it.

For details on firmware update and save or load setup menu settings, refer to the Maintenance Manual Volume 1.

2-14

Chapter 2 Location and Function of Parts