Setting an initial time code value
Use the following procedure.
RESET button
Z
1,2,3,4,5,61Set the CTL/TC to TC.
2Press the F6 (TCGSET) button.
The function menu display changes as follows.
TCG 00 : 00 : 00 : 00
SET 
SET EXIT
The first digit of the time code value (8 digits: hours, minutes, seconds, and frames) flashes.
To set all digits to zero
Press the RESET button.
3Press the F1 (T) or F2 (t) button to select the digit to be changed.
Pressing the F2 (t) button moves the flashing digit position to the right, and pressing the F1 (T) button moves the flashing digit position to the left.
4Turn the MULTI CONTROL knob or press the F3 (+)/F4
5Until all the digits are set as required, repeat steps 3 and 4.
6Press the F5 (SET) button.
When the RUN is set to FREE in function menu page 1, the time code value immediately starts advancing.
Setting the time code value to the real time
With the settings in function menu page 1 set as follows, carry out the foregoing procedure under the heading “Setting an initial time code value”. In steps 3 and 4, set the value slightly after the current time, then carry out step 6 at the instant the real time catches up with the setting.
TCG (F1): INT
PR/RGN (F2): PRESET
RUN: FREE
DF: DF (59.94i, 29.97PsF mode only)
Setting a user bit value
The user bit values recorded on the time code track provide for eight hexadecimal digits, which can be used to hold the date, time, or other information.
Use the following procedure.
1Set the CTL/TC to UB.
2Carry out the procedure in steps 2 to 6 under the heading above, “Setting an initial time code value”.
You can set each digit to any hexadecimal value, represented by 0 to 9, and A to F.
Note
If any of the settings in item G03 of the shot mark operation menu is set to ON (to write a recording start mark), then the user bits are overwritten with the shot mark data for 20 frames from the start of recording in crash record mode, assemble edit mode, or insert edit mode.
Playback and Recording 4 Chapter
Chapter 4 Recording and Playback |