Adjusting the level
Slight adjustments to the system can enhance your sound enjoyment.
LEVEL 
LEVEL
INPUT
LEVEL
Turn LEVEL to adjust the volume.
Set the volume level to best suit your preference according to the program source.
Note
Do not set the volume of the sub woofer to maximum. Extraneous noise may be heard.
7:Adjusting the speaker levels and balance
—TEST TONE
Adjust the speaker levels and balance while listening to the test tone from your listening position. Use the remote for the operation.
Tip
The receiver employs a test tone with a frequency centered at 800 Hz.
1 Press ?/1 to turn on the receiver.
2 Press TEST TONE.
“T. TONE” appears in the display and the test tone is output from each speaker in sequence.
Front (left) t Center t Front (right) t Surround (right) t Surround (left) t Sub woofer
3 Adjust the speaker levels and balance using the LEVEL menu so that the level of the test tone sounds the same from each speaker.
For details on the LEVEL menu settings, see page 26.
Tips
•To adjust the level of all speakers at the same time, press MASTER VOL +/– on the remote or turn MASTER VOLUME
•The adjusted value are shown in the display during adjustment.
4 Press TEST TONE again after adjustment.
The test tone turns off.
Notes
•Although these adjustments can also be made via the front panel using the LEVEL menu (when the test tone is output, the receiver switches to the LEVEL menu automatically), we recommend you follow the procedure described above and adjust the speaker levels from your listening position using the remote.
•The bass redirection circuitry is always active, so you may hear some sound output from the sub woofer when test tone is output from other speakers. However, this is not a malfunction.
