HDMI Device List Displays a list of connected equipment that is compatible with control for HDMI.
~
•You cannot use “Control for HDMI” if the TV operations are linked to the operations of an audio system that is compatible with control for HDMI.
Auto | You can run the initial | ||
| select the language and country/area, or tune in all available channels again. | ||
| Even if you have made the settings when you first connected the TV, you may need | ||
| to change the settings after moving house, or to search for newly launched | ||
| channels. |
|
|
|
|
| |
Power Saving | Reduces power consumption of the TV by adjusting the backlight. |
| |
| When you select “Picture Off”, the picture is switched off, and the | (Picture Off) | |
| indicator on the TV front panel lights up in green. The sound remains unchanged. | ||
|
|
| |
Light Sensor | On | Automatically optimises the picture settings according to the | |
|
| ambient light in the room. |
|
|
|
|
|
| Off | Turns off the “Light Sensor”. |
|
~
•Do not put anything over the sensor, doing so may affect its function. See page 16 to check the position of the sensor.
Logo Illumination | Lights up and turns off the Sony logo on the front of the TV. |
Panel Key | Constantly lights up the touch sensors on the front of the TV. |
Illumination |
|
|
|
PC Power | Switches the TV to standby mode when the TV receives no signal from the PC |
Management | input source for 30 seconds. |
|
|
Language | Sets the language displayed on the menu screens. |
|
|
Product Information | Displays product information of the TV. |
|
|
All Reset | Resets all settings to factory settings and displays the initial |
~
•Do not turn off the TV or press any buttons during “All Reset” (takes about 30 seconds).
•Settings for the Digital Favourites lists, country/area, language, and auto tuned channels will also be reset to factory settings.
Analogue Set-up
Programme List | Select “Off” to hide the list of analogue channels from the XMB™ |
Display | (XrossMediaBar). |
|
|
1 Digit Direct | When “1 Digit Direct” is set to “On”, you can select an analogue channel using one |
| preset number button (0 – 9) on the remote. |
~
•When “1 Digit Direct” is set to “On”, you cannot select channel numbers 10 and above by entering two digits on the remote.
Auto Tuning | Tunes in all the available analogue channels. |
| You can retune the TV after moving house, or to search for newly launched |
| channels. |
.
2Press F/f to select the new position for the channel, then press .