Setting Up the Channel List
Using Initial Setup
zIf you are using a CableCARD, Auto Program is disabled for the CABLE input.
After you finish connecting the TV, you need to run the Initial Setup feature, which automatically creates a list of available analog and digital channels. The Initial Setup screens appear when you turn on your TV for the first time after hooking it up.
To run Initial Setup
1Press POWER to turn on the TV. The Initial Setup screen appears.
2Using the remote control, move the highlight to the desired
language, then press 
to select that language.
3The next screen instructs you to connect your cable/antenna. Check that you’ve connected your signal source correctly.
To start Auto Program, highlight Yes and then press 
. Auto Program automatically creates a list of receivable analog and digital channels. Auto Program may take 50 minutes or more to complete. A progress bar is displayed while the channel list is being created.
The lowest numbered channel is displayed.
To run Auto Program again at a later time
❑Use the Auto Program feature as described on page 89.
To add individual digital channels
Use the Digital Channel feature as described on page 89.
To reset the TV to factory settings
1Press POWER to turn on the TV.
2Hold down RESET on the remote control.
3Press POWER on the TV.
4Release RESET. (The TV will turn itself off, then back on.)
Setup
SETUP
SETUP
SETUP
SETUP
43
