![](/images/backgrounds/187988/bg1c.png)
Installing and Connecting the Projection TV
28
Model name1[KP-46WT500] Model name2[KP-51WS500] Model name3[KP-57WS500] Model name4[KP-65WS500]
[4-088-847-12]
Connecting a Digital TV Receiver
Disconnect all power sources before making any connections.
1Using three separate component video cables, connect the Digital TV
Set-top box’s Y, PB and PR jacks to the projection TV.
2Using an audio cable, connect the Digital TV Set-top box’s Audio OUT
jacks to the projection TV’s AUDIO IN jacks.
✍The Y, PB and PR jacks do not provide audio, so audio cables must
be connected to provide sound.
✍Component video connection is necessary to view 480p, 720p, and
1080i formats. You may also use the S VIDEO or Composite Video
connections, however, component video (Y, PB, PR) will provide the
best picture quality for all format types.
Be sure to read the
Set-top box manual.
Some Digital TV
Receivers are equipped
with a DVI connection.
Refer to your Digital TV
Receiver manual for
setup instructions using
this connection.
z
z
VMC-10HG (not supplied)
Digital TV Set-top box
RK-74A (not supplied)
AUDIO-R (red)
AUDIO-L (white)
Rear of projection TV
PR
PB
Y
✍You cannot record the signal from any equipment connected into the
Y, PB and PR connectors.
✍This projection TV is not compatible with digital TV receivers
configured with RGB or VGA output connectors.
✍The DVI connection is compliant with the EIA-861 standard and is
not intended for use with personal computers.
01COV.book Page 28 Tuesday, July 30, 2002 3:46 PM