Sony KV-21FX30E, KV-21FX30B Flash Timing Example e.g. error number, How to enter into Table

FE-2 SELF DIAGNOSTIC SOFTWARE

The identification of errors within the FE-2 chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant device number will be displayed through the LED (Series of flashes which must be counted) See table 1., non fatal errors are reported using this method.

Each time the software detects an error it is stored within the NVM. See Table 2.

Table 1

Error Message	LED
	Code
No error	00
Reserved	01
OCP ( Over Current Protection )	02
Not Used	03
No Vertical Sync	04
IKR Error at power on	05
IIC bus clock and/or data lines low at power on	06
NVM no IIC bus acknowledge at power on	07
Not Used	08
Tuner no acknowledge at power on	09
Sound Processor Error	10
Jungle controller 8 volts error	11

Flash Timing Example : e.g. error number 3

StBy LED

ON	ON	ON
	OFF	OFF

How to enter into Table 2

1.Turn on the main power switch of the TV set and enter into the‘Stanby Mode’.

2.Press the following sequence of buttons on the Remote Commander.

i+	5	-
(ON SCREEN	(DIGIT 5)	(VOLUME -)	(TV)
DISPLAY)

3.The following table will be displayed indicating the error count.

Table 2

ERROR MENU
E02	OCP	(0, 255)	0
E03	OVP N/A	(0, 255)	0
E04	VSYNC	(0, 255)	0
E05	IKR	(0, 255)	0
E06	IIC	(0, 255)	0
E07	NVM	(0, 255)	0
E08	JUNGLE	(0, 255)	0
E09	TUNER	(0, 255)	0
E10	SOUNDP	(0, 255)	0
E11	8V	(0, 255)	0
WORKING TIME
HOURS			2
MINUTES			11

Note: To clear the error count data press ‘80’ on the Remote commander.

5