Setting Up the TV
If you connect two VCRs, you can record from one VCR to the other while using your TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1 Using an A/V cable, connect the playback VCR’s AUDIO and VIDEO OUT jacks to the recording VCR’s AUDIO and VIDEO IN jacks.
2 Using an A/V cable, connect the recording VCR’s AUDIO and VIDEO OUT jacks to the TV’s AUDIO and VIDEO IN jacks.
Cables are often
Rear of Media Receiver Unit
S VIDEO
VCR (playback) | VCR (recording) |
VIDEO
AUDIO L
1
IN
A/V cable
✍To perform tape editing, set the TV to the video input intended for playback by pressing TV/VIDEO on the remote control.
✍You may need to change the video input on your VCR. See your VCR’s operating manual for instructions.
✍If your VCRs have S VIDEO jacks: For best picture quality, use an
S VIDEO connection instead of the yellow video cable on your combined A/V cable.
Using an S VIDEO cable, connect the playback VCR’s S VIDEO OUT jack to the recording VCR’s S VIDEO IN jack. S VIDEO does not provide audio, so audio cables must be connected to provide sound.
✍You cannot record signals from equipment connected to the YPBPR input.
40