Additional Information
“TOC Reading” appears for a long time
“TOC Reading” will be displayed for longer than normal when an MD containing many songs is loaded.
Limitations when recording over an existing track
•The correct remaining recording time may not be displayed.
•You may find it impossible to record over a track if that track has been recorded over several times already. If this happens, erase the track using the Erase Function (see page 20.)
•The remaining recording time may be shortened out of proportion to the total recorded time.
•Recording over a track to eliminate noise is not recommended since this may shorten the duration of the track.
•You may find it impossible to label a track while recording over it.
The correct recorded/playing time may not be displayed during playback of
Troubleshooting
If you experience any of the following difficulties while using the recorder, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer.
The recorder does not record.
/The MD is
/The recorder is not connected properly to the sound source. Make connections properly to the sound source.
/The recording level is not adjusted properly (in case of input through LINE (ANALOG) IN.) Turn REC LEVEL to adjust the recording level properly (see page 11.)
/A premastered MD is inserted. Replace it with a recordable MD.
/There is not enough time left on the MD. Replace it with another recordable MD with fewer recorded tracks, or erase unnecessary tracks.
/There has been a power failure or the AC power cord has been disconnected during recording. Data recorded to that point may be lost. Repeat the recording procedure.
The recorder does not work during
/The currently selected CD player type (CD player or video CD player) does not match the CD player being used. Reset the CD player type (see page 14.)
The sound has a lot of static.
/Strong magnetism from a television or a similar device is interfering with operations. Move the recorder away from the source of strong magnetism.
The recorder does not operate or operates poorly.
/The MD may be damaged (“Disc Error” appears.) Take the MD out and insert it again. If “Disc Error” remains, replace the MD.
The recorder does not play back.
/Moisture has formed inside the recorder. Take the MD out and leave the recorder in a warm place for several hours until the moisture evaporates.
/The recorder is not on. Press U to turn the recorder on.
/The MD is inserted in the wrong direction. Slide the MD into the disc compartment with the label side up and the arrow pointing towards the opening until the recorder grips it.
/The MD may not be recorded. Replace the disc with one that has been recorded.
Note
If the recorder does not operate properly even after you’ve attempted the prescribed remedies, turn off the power, then reinsert the plug into the power outlet.
35