3 Rotate the dial to adjust the volume of front/rear speakers.

Decreases speaker volume

Increases speaker volume

After three seconds, the display returns to the normal playback mode.

Adjusting the volume of the subwoofer(s)

1 Press (SOURCE) to select a source (tuner, CD, or MD).

2 Press (SOUND) repeatedly until “SUB” appears.
Selecting the cut-off frequency of the front/rear speakers

1 Press (SOUND) for two seconds.

2 Press (SOUND) repeatedly to select “F” or “R.”

3 Press (5) (t).

4 Rotate the dial to select the cut-off frequency.

off y 78 Hz y 99 Hz y 125 Hz y 157 Hz

y198 Hz

If you want to adjust the volume of the front or rear speakers at this time, press (2) (T) and rotate the dial as in step 2 of “Adjusting the fader (FAD).”

5 Press (SOUND) for two seconds. When the effect setting is complete, the normal playback mode appears.

3 Rotate the dial to adjust the volume.

After three seconds, the display returns to the normal playback mode.

Tip

When you rotate the dial to turn the volume all the way down, “Sub ATT” appears and the cutout frequency of the subwoofer is disabled.

Adjusting the frequency of the subwoofer(s)

To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). By setting the cut-off frequency (see the diagram below), the subwoofer(s) will output only low frequency signals so you can get a clearer sound image.

Level

Cut-off frequency

 

 

62

78

99

125 157

Frequency (Hz)

 

 

 

 

30