Turning off the display

automatically (for TV/VIDEO 1/VIDEO 2 only)

You can set the display to turn off automatically after a predetermined period of time (15, 30, 45, 60, or 90 minutes).

Press the SLEEP button on the remote control repeatedly.

Each time you press the SLEEP button, the period of time changes as follows:

O f f

15 min

SLEEP

30 min

45 min

60 min

90 min

To cancel the Sleep timer

Press the SLEEP button repeatedly until “Off” appears.

Tips

•If you turn the display off, and then turn it on again, the Sleep timer is set to off.

•While the Sleep timer is activated, the 1 (power) indicator lights up in red.

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the following messages appears on the screen. To solve the problem, see “Trouble symptoms and remedies” on page 38.

If “Out of Range” appears on the screen

This indicates that the input signal is not supported by the display’s specifications. Check the following items.

For more information about on-screen messages, see “Trouble symptoms and remedies” on page 38.

If “xxx.x kHz / xxx Hz” is displayed

This indicates that either the horizontal or vertical frequency is not supported by the display’s specifications.

The figures indicate the horizontal and vertical frequencies of the current input signal.

I NFORMA T I ON

DV I - D : PC 1

Ou t o f R a n g e

XXX . XKH z /

XXXH z

 

 

If “Resolution i1280 × 768” is displayed (MFM-HT75W)

This indicates that the resolution is not supported by the display’s specifications (1280 × 768 or less).

I NFORMA T I ON DV I - D : PC 1

Ou t o f R a n g e

R e s o l u t i o n > 1 2 8 0 X 7 6 8

If “Resolution i 1280 × 1024” is displayed (MFM-HT95)

This indicates that the resolution is not supported by the display’s specifications (1280 ⋅ 1024 or less).

I NFORMA T I ON DV I - D : PC 1

Ou t o f R a n g e

R e s o l u t i o n > 1 2 8 0 X 1 0 2 4

If “No Input Signal” appears on the screen

This indicates that no signal is being input via the currently selected connector.

I NFORMA T I ON

DV I - D : PC 1

N o

I n p u t S i g n a l

Go

t o P o w e r S a v e

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

36