Problems and remedies (continued)
Optional components
There is no sound.
•Refer to General item “ There is no sound.” on page 64 and check the condition of the system.
•Connect the component properly (see page 61) while checking:
—if the cords are connected properly.
—if the cord plugs are firmly inserted all the way.
•Turn on the connected component.
•Refer to the operating instructions included with the connected component and start playing.
If other troubles not described above occur, reset the system as follows:
1Unplug the power cord.
2Plug the power cord back in.
3Press x, ENTER, and ?/1 at the same time.
4Press ?/1 to turn on the system.
The system is reset to the factory settings except for DVD settings. All the settings other than DVD settings you made are cleared.
Messages
One of the following messages may appear or flash in the display during operation.
NO DISC
•There is no disc in the disc tray.
“PROTECT” and “ PUSH POWER” appear alternately.
•A strong signal was input. Press ?/1to turn off the system, leave the system turned off for a while, then press ?/1again to turn on the system. If “ PROTECT” and “ PUSH POWER” appear alternately even after the system is turned on again, press ?/1 to turn off the system and check the speaker cord.
PUSH STOP
• You pressed PLAY MODE during play.
READING
•The system is reading the TOC information of the disc. Some buttons are not available.
WAIT
• The function is switching to the tuner.
The disc tray does not open and “ LOCKED” appears.
•Contact your Sony dealer or local authorized Sony service facility.