Tuner
Presetting radio stations
You can preset 20 stations for FM and 10 stations for AM.
1
2 Press and hold TUNING + or – until “AUTO” appears in the display.
Scanning stops when the system tunes in a station. “TUNED” and “STEREO” (for a stereo program) appear.
MHz
3 Press TUNER MEMORY.
A preset number appears in the display. The stations are stored from preset number 1.
Preset number
4 Press ENTER (Tuner or remote).
5 Repeat steps 1 to 4 to store other stations.
To tune in a station with a weak signal
Press TUNING + or – repeatedly to tune in the station manually.
To set another station to an existing preset number
Start over from step 1. After step 3, press PRESET + or – repeatedly to select the preset number where you want to store a new station, then proceed to step 4.
Tip
The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.
42
To change the AM tuning interval (Except for European and Saudi Arabian models)
The AM tuning interval is factory set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the power. While holding down ENTER (Tuner), turn the power back on. Release ?/1 first, then release ENTER (Tuner). Press ?/1 again. The AM tuning interval is changed. When you change the interval, AM preset stations will be erased. To reset the interval, repeat the same procedure.
Listening to the radio
—Preset Tuning
Preset radio stations in the tuner’s memory first (see “Presetting radio stations”).
1 Press TUNER/BAND repeatedly to select the band you want.
2 Press PRESET + or – repeatedly to tune in the preset station you want.
Preset number | Frequency |
MHz
To | Do this |
Turn off the radio | Press ?/1. |
|
|
To listen to
In step 2, press TUNING + or – repeatedly (Manual Tuning) or press and hold TUNING + or – (Automatic Tuning).
Notes
•When the TUNER function is selected, the OSD does not appear on the screen.
•When DVD is selected as the current function and TUNER/BAND is pressed to select the TUNER function, some time may be necessary before the function can be switched.
•When you change the function from DVD to TUNER, “WAIT” may flash on the front panel display. While this flashes, there is no audio output.